AApex S&W M&P Shield Flat-Faced Enhancement kit
What It Does
This kit is a combination of the Apex Shield Duty/Carry Action Enhancement Kit and the Apex Shield Flat-Faced Action Enhancement Trigger. The Trigger Kit directly replaces the factory hinged trigger with a solid aluminum trigger body which reduces pre-travel and over-travel by approximately 20%. It features a smooth, flat face with a center mounted pivoting safety that maintains factory safety values.
The Apex Shield Duty/Carry Kit was designed to provide the M&P Shield pistol owner a smooth, consistent trigger pull that is approximately 2 lbs lighter (based on variations in factory tolerances) with the advantages of shorter over-travel and more detectable trigger reset. The kit itself is engineered to be drop-in and should not require further gunsmithing. However, armorer or gunsmith installation of the Ultimate Striker Block (USB) into the Shield slide is strongly recommended**.
– Reduces trigger pull by approximately 2 lbs.
– Smooth uptake and reset
– Reduces pre-travel
– Reduces over-travel
– Reduced reset
– Center mounted pivoting safety maintains factory safety values
Applicable To What Gun(s)
Works with all Smith & Wesson M&P Shield Pistols in 9mm and .40 calibers.
In The Package
1 ea. Aluminum Shield Flat-Faced Action Enhancement Trigger
1 ea. Trigger Return Spring Installation Shield Slave Pin (to assist with trigger return spring installation)
1 ea. Fully machined .45 Sear
1 ea. Ultimate Striker Block Kit
1 ea. Ultimate Striker Block
1 ea. Striker Block Spring
1 ea. Talon Tactical tool
1 ea. Shield Carry Spring Set
1 ea. Sear Spring (1/8")
1 ea. 4 lb Rated Trigger Return Spring
Shield Trigger Bar Install PDF – This is the recommended process for installing the trigger bar in an Apex replacement trigger for the S&W M&P Shield.